C.A.R.D. 060 Instalační manuál stáhnout pdf (Strana 11)

light from the signal reflected from the coast as well as one from

the primary source. Again, by rotating the sensitivity knob a few

degrees clockwise, the reflected signal should disappear.

A remote horn can be installed using the pin #7 of the antenna

plug.

Remove the shell covering plug.

Locate pin #7 (this is the only one without a wire).

Connect a wire to the negitive side of the buzzer.

The positive side of the buzzer is connected to the positive side of

your battery.

We recommend that you install an on-off switch in the 12 volt

line, to turn off the remote when not needed.

For help with this installation please call SSE for assitance at:

1 - 888 - 475-5364

Voice: 757 - 480-5508

www.survivalsafety.com

Page# 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

C.A.R.D. 060 Instalační manuál Strana 11